Skip to main content
Help
Editing Step 3 —

Step Type:

Drag to rearrange

Repeat this step for each of the 4 Y End Plates, installing one on each corner of your base. Do not fully tighten before making sure your frame is perfectly square - squareness is really important! Best way to check squareness is to measure the diagonals of the rectangle formed by the 4 profiles. They should have the exact same length.

Lock Collar 8mm. Set it in position, but don't tighten for now.

Precision Shim 12x8x1mm

688ZZ Ball Bearing

Y End Plate

Low Profile Screw M5x15mm (for C-Beam profiles)

Low Profile Screw M5x12mm (for 2040 profiles)

T-Nut M5

Your contributions are licensed under the open source Creative Commons license.