Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Bondtech LGX Lite assembly

EVA3 drive_lgx_lite Printed Part

M3x8 Cap Head Screw

Install an M3x8 screw into each of the four positions shown. This will secure the LGX Lite extruder to the printed part

Take care not to over tighten the M3 screws as you can damage the printed part or the LGX Lite

Re-install the two M3x25 screws into the LGX Lite extruder

Your contributions are licensed under the open source Creative Commons license.