Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Assembly from the previous step

M2.5x8 Cap Head Screw

Phaetus Rapido HF assembly

Insert the four M2.5x8 screws through the printed part and fasten them into the Rapido HF hotend

43.7mm PTFE Tube

Insert the PTFE tube as shown, ensure it is fully pushed down into the hotend

Set this assembly aside until Step 28

Your contributions are licensed under the open source Creative Commons license.