Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Install the MGN12 EVA3 Connector

Place the EVA3 top assembly atop the MGN12 carriage as shown

Make sure the holes on the side of the printed part face towards the left of the x-axis

M3x8 Cap Head Screw

Fasten all four M3x8 screws to secure the EVA3 top assembly to the MGN12 carriage

Slide the X-axis left and right along the rail to make sure it moves smoothly

If the carriage binds at all, slightly loosen the M3x8 screws and check again

Your contributions are licensed under the open source Creative Commons license.