Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Check that the CoreXY belt is still positioned from Step 15

Place the EVA3 face_belt_grabber printed part over the exposed belt end

Fasten two M3x8 screws through the EVA3 face_belt_grabber and into the universal face

Repeat the process on the left side of the EVA3 assembly

Take care not to over tighten the M3 screws as you can damage the printed parts

Your contributions are licensed under the open source Creative Commons license.