Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Loose end of the lower CoreXY belt

Mark the belt where it meets the EVA3 assembly. This can be with a marker, or simply by holding it.

From the mark, towards the loose end of the belt, measure 24mm (or count 12 teeth)

It is better to cut the belt too long than too short! If you are unsure, cut it longer than expected, you can always remove more if needed

Double check your measurements and then cut the belt at this point

Insert the cut end of the belt into the core_xy_belt_grabber printed part

Insert an M5 nylon locking nut into the core_xy_belt_grabber as shown

Insert the core_xy_belt_grabber assembly into the EVA3 assembly as shown

Your contributions are licensed under the open source Creative Commons license.