Place the top part on the assembly and fasten it with the M5 screws from underneath. The parts need to be flush but not so tight that they'll stop the idlers from rotating
Do not over tighten or you will be compressing the bearings.
Fasten the Countersink Screws at the top - remember that the T-Nuts inside need to rotate and grab the inside of the 3030 extrusion
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.