Skip to main content
/

Site Navigation

Your Account

Choose Language

Help
Editing Step 3 —

Step Type:

Drag to rearrange

Assemble 2 side frames by fitting the T-Nuts inside the slots and tightening the screws on the Cast Corner Brackets.

CAUTION: if you're using levelling feet, you will notice that one end of each A profile is threaded, so you can screw in the feet. Make sure you orient those profiles so the threaded ends are at the bottom.

Make sure your side frames are perfectly square after assembly. Easiest way to check this is to measure the diagonals of the frame, they should be the same length. If they're not, untighten the screws and adjust.

On the variants Workbench - Standard 1510 and 1515, the top B profiles are 4080 instead of 4040 (they have double the width shown on the picture).

Take note of how the profiles should be joined.

Your contributions are licensed under the open source Creative Commons license.