Pending Edits to 03. Y-Axis Motor & Idler Assemblies

Introduction edited

Edited by Stan Stocker (3)

(You don’t have enough reputation to patrol this edit.)

Time Required Min
40 minutes
Time Required Max
40 minutes
Conclusion
In step 8, observe the orientation of the 3030 square nuts. There is not enough room to rotate these 90 degrees, so pay attention. When placing the second shim in place, sticking it to a piece of tape will let you wiggle it into place. Once caught on the tip of the machine screw, just pull the tape out before snugging up. Makes like much easier than fooling with tweezers or skinny screwdrivers.