Pending Edits to 07. Bed Arm Assemblies
Note: Accepting or denying any edit implicitly applies to all earlier pending edits to the same step or introduction.
Step #19 edited: [Step edited]
Edited by Jeremy (1)
(You don’t have enough reputation to patrol this edit.)
| - | [title] Install the front |
|---|---|
| + | [title] Install the front left bed arm & lead screw - Part 2 |
| [* 2] Rigid Lead Screw Coupler | |
| [* 3] Insert the lead screw fully into the rigid coupler | |
| [* 4] Fasten the marked M3 screw to secure the lead screw to the NEMA17 motor |
Step #18 edited: [Step edited]
Edited by Jeremy (1)
(You don’t have enough reputation to patrol this edit.)
| - | [title] Install the front |
|---|---|
| + | [title] Install the front left bed arm & lead screw - Part 1 |
| [* 2] Front left bed arm assembly | |
| [* 3] 380mm TR8x4 lead screw | |
| [* 4] Install the lead screw through the front bed arm and decoupler | |
| [* 9] ***Do not force*** the lead screw through the POM nut on the decoupler as this can cause damage. It should thread through smoothly | |
| [* 10] Continue threading the lead screw through the arm until it reaches the rigid lead screw coupler on the front left Z-axis motor mount | |
| [* 5] M3x20 Cap Head Screw | |
| [* 10] Install each screw through the bed arm assembly as shown, then fasten the arm to the linear rail carriage |
Step #17 edited: [Step edited]
Edited by Jeremy (1)
(You don’t have enough reputation to patrol this edit.)
| - | [title] Install the front |
|---|---|
| + | [title] Install the front right bed arm & lead screw - Part 2 |
| [* 2] Rigid Lead Screw Coupler | |
| [* 3] Insert the lead screw fully into the rigid coupler | |
| [* 4] Fasten the marked M3 screw to secure the lead screw to the NEMA17 motor |
Step #16 edited: [Step edited]
Edited by Jeremy (1)
(You don’t have enough reputation to patrol this edit.)
| - | [title] Install the front |
|---|---|
| + | [title] Install the front right bed arm & lead screw - Part 1 |
| [* 2] Front right bed arm assembly | |
| [* 3] 380mm TR8x4 lead screw | |
| [* 4] Install the lead screw through the front bed arm and decoupler | |
| [* 9] ***Do not force*** the lead screw through the POM nut on the decoupler as this can cause damage. It should thread through smoothly | |
| [* 10] Continue threading the lead screw through the arm until it reaches the rigid lead screw coupler on the front right Z-axis motor mount | |
| [* 5] M3x20 Cap Head Screw | |
| [* 10] Install each screw through the bed arm assembly as shown, then fasten the arm to the linear rail carriage |
Introduction edited
Edited by Josh Ward (2)
(You don’t have enough reputation to patrol this edit.)
| Time Required Min |
1 hour
|
|---|---|
| Time Required Max |
1 hour
|