Pending Edits to 02. XY Drive Assembly
Note: Accepting or denying any edit implicitly applies to all earlier pending edits to the same step or introduction.
Step #6 edited: [Step edited]
Edited by Jakob Ventzel (1)
(You don’t have enough reputation to patrol this edit.)
| [title] Prepare the top parts | |
| - | [* 2] |
| + | [* 2] Fetch the three ***Countersink Screw M6x14*** (the countersunk ones) and thread those through the ***xy_motor_cage_top_left*** printed part |
| [* 6] Attach the ***3030 M6 T-nuts***, don't tighten fully | |
| [* 4] Pull the ***M5 Hex Locking Nuts*** into place with the nut pull technique (described in the [guide|78|Preparations guide|stepid=477]) | |
| [* 1] Repeat on the ***xy_motor_cage_top_right*** part |
Step #5 edited: [Step edited]
Edited by Ben Finklea (2)
(You don’t have enough reputation to patrol this edit.)
| [title] Attach the right drive base | |
| - | [* 1] Repeat the previous step on the right side |
| + | [* 1] Repeat the previous step on the top back right side. |
Step #4 edited: [Step edited]
Edited by Ben Finklea (2)
(You don’t have enough reputation to patrol this edit.)
| [title] Attach the left drive base | |
| - | [* 1] Attach the left drive base to the left top corner of the printer |
| + | [* 1] Attach the left drive base to the left top back corner of the printer |
| [* 1] Make sure the plate is in the corner and tighten the ***M6 screws*** to lock the ***T-Nuts*** in place | |
| [* 10] The T-Nuts need to rotate within the 3030 extrusion for a secure attachment |
Step #1 edited: [Step edited]
Edited by Ben Finklea (2)
(You don’t have enough reputation to patrol this edit.)
| [title] Identify the printed parts | |
| - | [* 1] Fetch these six parts and look for letters indicating which parts belong to which side: |
| - | [* 2] The letter ***L*** for left |
| - | [* 3] The letter ***R*** for right |
| - | [* 9] The sides do not differ much, but the parts are ***NOT*** mirrored |
| + | [* 1] Fetch these six parts: XY motor cage left, XY motor cage right, XY motor cage bottom left, XY motor cage bottom right, motor support left, motor support right. |
| + | [* 1] Look for letters indicating which parts belong to which side: |
| + | [* 2] The letter ***L*** for left (when facing the front of the printer) |
| + | [* 3] The letter ***R*** for right (when facing the front of the printer) |
| + | [* 9] The sides do not differ much, but the parts are ***NOT*** mirrored. |