Pending Edits to 03. XY Idler Assembly
Note: Accepting or denying any edit implicitly applies to all earlier pending edits to the same step or introduction.
Step #5 edited: [Step edited]
Edited by Tyler Suard (1)
(You don’t have enough reputation to patrol this edit.)
| [title] Finish Right XY Idler assembly | |
| [* 2] The order for the bearing stack from the bottom is: shim, idler, shim, 2x 6mm spacer, shim | |
| [* 6] Thread the bearing stack onto the ***Cap Head Screw M5x40*** | |
| [* 4] Attach the M5 nut from the bottom, do not over tighten - it should be snug but should not prevent the idler from spinning | |
| + | [* 1] If you are having trouble getting the bearing stack into place, thread the bearing stack onto a thread or a thin wire, then pull the ends of the wire through the holes in the mount, from the inside out. The bearing stack will slide into place. |
Introduction edited
Edited by ratrig@topgun.dk (3)
(You don’t have enough reputation to patrol this edit.)
| Time Required Min |
1 hour
|
|---|---|
| Time Required Max |
1 hour
|
| Difficulty |
Moderate
Difficult
|