Samuel Lazea

@ratrig

I also checked further and I saw this:

Step 2 - Bed wiring

Complete the wiring connections for the bed heater, follow here.

But if you follow the link there is no mention nor picture of the bed wiring.

@ratrig in the main AC wiring I see only one AC cable going to the SSR. That is the brown L coming from the source. What cable should be in the second connection on the SSR?

This step is so painful, it's crazy. I don't mind crimping things but I do hate to crip it in place instead of crimping it easier on a bench top. Also, it would not hurt to give 1-2 extra connectors in case someone does it wring once

The picture is so confusing. You need to read carefully the text and replace in your mind the colors otherwise you end up swapping wires. Also, I see no mention of cutting the existing connector from the 4028 fan @ratrig

This step could use a bit more explanation cause it's hard to understand it all the way it's explained

@ratrig Diagram is confusing. In Rapido 2 heater cables are RED and the PT1000 are BLUE. This can lead to burning of the PT1000 if people are not careful

@ratrig Diagram is confusing. In Rapido 2 heater cables are RED and the PT1000 are BLUE. This can lead to burning of the PT1000 if people are not careful

This step of connecting the Rapido blue cables to the EBB board is nearly impossible with the EBB mounted. Best would be to do this before to make sure the wires sit properly and that there are no strands to create a short circuit

The power wires are rather flimsy. They would be a lot better if they were both connected. This would give them support and prevent twisting

Would be good to specify also instead of Z0, Z1 and Z2 the location of the steppers like Left, Right and Middle. Would make it easier to trace cables