Help
Stephen Schlie
@heschlie
Stephen Schlie
| 1 | Reputation |
|---|---|
| 0 | Guides |
| Member Since 02/12/2022 | |
| 1 | Reputation |
|---|---|
| 0 | Guides |
| Member Since 02/12/2022 | |
My kit had the same thing, no M5x14 but 3x M5x12 /shrug
Why not just put the locking nuts for the hinges here, kinda hard to move the part around without them fastened?
Initially tried 222nm, but ordered the wrong length so I couldn’t find an angle that would keep the lid closed and give me a reasonable opening. I’ve done 156nm, and 178nm both too weak. I could probably get the 178nm to work but it is super hard to fiddle around with this so I have ordered a set of 200nm, and 245nm as well hopefully Amazon is picky about letting me send a bunch of these back as the whole resting it on the wall turns out to not be as convenient as it seemed.
Seriously, kinda annoyed me getting to this part and having to undo… like 50-60 screws on the 500mm model, can we please at least put a mention in the assembly step before this is required, I have to imagine a lot of folks are buying the fully enclosed kit.
Yea, the included struts didn’t stand a chance at holding the 500mm lid, after futzing with it, and trying a couple of different strength struts I finally said screw it and just left them out, the lid flips up enough to rest it on the wall behind my printer.