Pedro Sánchez

Had to use M3x25 where M3x20 were supposed and M3x30 where M3x25 were supposed.

Had to use M3x14 screws, M3x12 didn’t reach the nut.

There’s a small gap for the idler assembly which makes the idler be able to move up and down a little bit. Right side stays in it’s place whereas left one is free to move. It’s not a lack of tighten, I thin the printed part is longer on this side as I measured with the calipper and it’s 0.2 longer on the organge mark in picture above than on the right side.