I can be difficult to feed the belt from the rear in through the slot, I found that if you feed a thin cable tie (zip tie /kable binde) from the opposite direction the belt will follow the curve of the cable tie.
I agree with David on that one. A tip for everyone, it’s not easy to stack the pieces so use a flexible rod or straw from underneath to align the idler pulley washers and spacers as you insert the 40mm m5 bolt. I used a straw from an air duster and it worked a treat.
I can be difficult to feed the belt from the rear in through the slot, I found that if you feed a thin cable tie (zip tie /kable binde) from the opposite direction the belt will follow the curve of the cable tie.
Be careful inserting the Cap Head Screw M6x12 I nearly split the part inserting mine, the fitment is very tight.
I agree with David on that one. A tip for everyone, it’s not easy to stack the pieces so use a flexible rod or straw from underneath to align the idler pulley washers and spacers as you insert the 40mm m5 bolt. I used a straw from an air duster and it worked a treat.