Come on RatRig you can do better than this. At least give us a hint to where the wires are routed because it isn't obvious from your instructions. The toolhead has been designed without a thought of wire routing. I have tried everything with this over several nights and I am very disappointed.
Some consistency here would be good the build guide shows the MCU with the drivers on the left and when we get to the ADXL section the drivers are on the right which could be confusing when it come to wiring.
Come on RatRig you can do better than this. At least give us a hint to where the wires are routed because it isn't obvious from your instructions. The toolhead has been designed without a thought of wire routing. I have tried everything with this over several nights and I am very disappointed.
You can not get heat inserts into the duct at the vents without melting the vents.
The hole for the heat insert that takes the screw to hold the probe in place is to shallow for the heat insert.
Some consistency here would be good the build guide shows the MCU with the drivers on the left and when we get to the ADXL section the drivers are on the right which could be confusing when it come to wiring.
Given that this is on the right I am assuming it is based on looking at the printer from the front?
The supplied Nidec fan has red, black, blue and white. No mention of how to wire the four wire fans that Ratrig supply very frustrating.
Nick D, did you find out which way the fan goes on and the orientation of the fan cable?