The CAD model has foam seals between the frame and the base plates. This is not mentioned here, nor is it mentioned in the Enclosure section
Advise not connecting it like this, else the fan will spin at 100% while the printer boots.
See my comment in step 68 - At this point, do not crimp the -ve wire to the JST-XH 2 pin, leave it bare
If you connect the PCF like this, it will spin at 100% while the printer boots.
Instead, see here: https://os.ratrig.com/docs/guides/4028/#...
Connect the +ve wire as directed, but connect the -ve wire to the -ve terminal of HE3 on the octopus
Then enter this in Printer.cfg:
[fan]
cycle_time: 0.00004
enable_pin: PB11
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.
The CAD model has foam seals between the frame and the base plates. This is not mentioned here, nor is it mentioned in the Enclosure section
Advise not connecting it like this, else the fan will spin at 100% while the printer boots.
See my comment in step 68 - At this point, do not crimp the -ve wire to the JST-XH 2 pin, leave it bare
If you connect the PCF like this, it will spin at 100% while the printer boots.
Instead, see here: https://os.ratrig.com/docs/guides/4028/#...
Connect the +ve wire as directed, but connect the -ve wire to the -ve terminal of HE3 on the octopus
Then enter this in Printer.cfg:
[fan]cycle_time: 0.00004enable_pin: PB11