Why is there no power switch (this may actually be required by law in the EU)? Also the AC wiring is open in the case (back of fuse can be touched) but the case itself is not grounded.
I recommend to use one lock nut on the side where the SSR can slide in (tighten it without the module). Then slide the SSR under it and tighten the other side with a regular M4 nut.
T0 is the left toolhead looking in from the front of the vcore.
Why is there no power switch (this may actually be required by law in the EU)? Also the AC wiring is open in the case (back of fuse can be touched) but the case itself is not grounded.
I recommend to use one lock nut on the side where the SSR can slide in (tighten it without the module). Then slide the SSR under it and tighten the other side with a regular M4 nut.
M6x16 are too long. I used the existing 2 M6 and didn't use the washers.