SirBuildALot

Its probably obvious, but use the guides to locate the linear rail, same as when it was first installed.

The instructions say to not use a sharp object, but its more helpful to say what to use. I used a large flat head screwdriver and it went in without a problem. Put one long side through and then put bracket down on a table and press the other side in with the blunt tip of the screwdriver.

The reference below is now to Step 39 instead of Step 55.

The reference below is now to Step 41 instead of Step 57.

Thanks for the warnings, I did this before mounting the hotend, and practiced trimming the thermistor insulation on the waste end. My wire stripper did not work to remove the insulation. I found that a razer knife (Exacto) worked best. I spread the fibers off to the side and trimmed them to expose the center conductor.

I used the advice in Step 5 and installed the SSR before putting the sides on. Then I used @sschueller advice and put in the bolt on the side that it can slide into, making this a little snug (so the SSR was held in place and didn't rattle during the next step). Then I put in the bolt on the other end with a lock nut, spinning the nut by holding it with my finger tip while rotating the bolt several turns until it reached the nylon insert and I couldn't hold it. Then I jammed one side of a small needle nose pliers into the side of the nut that it wanted to rotate towards, and turned the bolt to tighten it. It took less time to install than to write these instructions. I think this is basically what @victor did, I just added more explanation.

I did this by inserting a zip tie through the bottom hole, assembling the parts on it, held it with the axis of the screw vertical, removed the zip tie as I inserted the screw.