Reputation over time
It looks like this user hasn't gained any reputation yet.
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
Reputation Breakdown
No reputation gained yet.
847
Just ordered a set of spare pins on Amazon here... really wish there were a few spares.
Both of my smart sensors (IDEX) came with wires following a different color pattern. Mine are blue-yellow-green-red. Just make sure to double check yours before following the pictures.
As far as I can tell, you DO want to set the jumpers for UART mode, and the image used in this step is just a generic rendering not indicative of jumper position.
Checking the Fusion file, it looks like the sticker side of the fan should be facing inward, with the grille covering the open side.
I've got the same problem.
I'm wondering if RR is sending out a slightly different diameter of PTFE tubing now. I had to drill out the hole in the guide to accommodate the tube.
I also was unable to fit the provided PTFE tube section into the toolhead plate back in section 8 (or 9 for IDEX). I had to use a skinnier PTFE tube I happened to have on hand from another printer.
Had a similar issue. Managed to get the part assembled (twice for the IDEX kit), but I had to go incredibly slow and gentle. It took a lot of trial and error to get the fitting to thread in straight and I don't think I have it seated all the way in the hole, but I stopped short when it got extra difficult to continue.
This one has been the worst, but this feels like a common theme with the printed parts in this kit - they have all felt rushed and not well printed/inspected. Overhangs and surface finish have been mediocre to bad, and several parts have been warped or not fit correctly.