Reputation over time
It looks like this user hasn't gained any reputation yet.
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
Reputation Breakdown
No reputation gained yet.
850
Again, the color of the wires are swapped. Blue is the resistor and red is the heating.
Personally I should enlarge the hole for the VAOC cable (15.24) to 20 mm so the USB connector can passes through the hole.
And change the connector now before screwing him on (12.Electronics - step 65)
At the end the part was broken. I made a better part with a nut. Download at "https://www.thingiverse.com/thing:696318....
The remark at step 15 "Please verify the magnet polarity in relation to the magnets on the door panel. If the polarity is inverted, the magnets will repel each other instead of attracting." must be mentioned at this step in my opinion.
The other side of the camera cable (USB-C) doesn't fit through the hole (which is 16 mm) of the electric box so you had first put the cable with the small connector through that hole and then connect it to the camera.
My choice was a little tricky. I took a 9.0 mm drill with very low speed. After that a 9.5 mm drill and then it works.
(@RatRig)My suggestion would be, make a 10 mm hole and use a little superglue.
I used a little superglue. Simple and easy.
2 x M3 x 35 countersink needed for step 13!
I only see 14 yellow arrows not 16?
Page 1 of 2
Next