Reputation over time
It looks like this user hasn't gained any reputation yet.
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
Reputation Breakdown
No reputation gained yet.
861
I bought a kit on amazon that came with a bunch of connector shells (XH and PH) and bunch of 160mm wires with XH pins on one end and PH pins on the other. I was able to snap this cable together and install in less than a minute... well worth the price.
https://www.amazon.com/dp/B0CMZP2VFM
My kit from Feb 2025 included the Orbiter Smart Sensor and I found it easier to install the sensor before installing the toolhead mount and board: 04. Orbiter Smart Sensor - Rat Rig
It would be nice if those instructions were added or linked here in the official instructions.
For reference, the hot tightening procedure is documented here on page 18: Rapido-2F/Instructions Sheet/Rapido Hotend 2 Instruction Sheet.pdf at main · Phaetus/Rapido-2F · GitHub
Basically heat to 285 degrees and tighten to 2.5 Nm.
The printed parts I got in Feb 2025 fit correctly with the M5x60 and allowed it to sit flush.
I found it much easier to use a rubber mallet to gently tap the spacers into place in the printed part first and then slide it down over the screws.
With the kit and printed parts I received in February 2025 the M5x60 fit and allow vc4_xy_trim_left to sit flush.