02. V-Hive Enclosure - V-Minion

Written By: Miguel Cruz (and one other contributor)
  • Comments: 0
  • Favorites: 0
  • Completions: 1

Difficulty

Moderate

Steps

3

Time Required

Suggest a time??

Sections

1

Flags

0

  1. M6 x 14 mm Countersink Screw

    • M6 x 14 mm Countersink Screw

    • 3030 Drop In T-Nut M6

    • 90 Degree Corner Bracket.

    Edit

  2. Mounting Rails

    • Mounting Rails

    • 3x 90 Degree Corner Bracket Assembly

    • Make sure to place the 90 degree corner bracket assemblies accordingly to the distances bellow:

    • 115 mm

    • 122 mm

    • 215 mm

    • Keep the rounded side facing the printer.

    • Keep this side on the front of the printer.

    Edit

  3. Remove the V-Minion rubber feet before mounting it to the V-Hive Enclosure. Tighten the M6x14mm countersink screws to the V-Minion frame to ensure a stiff connection.

    • Remove the V-Minion rubber feet before mounting it to the V-Hive Enclosure.

    • Tighten the M6x14mm countersink screws to the V-Minion frame to ensure a stiff connection.

    • Center the printer on the V-Hive Enclosure.

    • Once the printer is in place proceed to tighten the four M6x14 screws on the rails to the frame.

    Edit
Finish Line

One other person completed this guide.

Author

with 1 other contributor

Miguel Cruz

Member since: 02/06/2023

4,783 Reputation

19 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 19

All Time: 740