Steps
3
- 02. Z-Axis Motor Assembly 3 steps
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
User-Contributed Guide
This guide is not managed by the site's staff.
Quiz
0
-
-
z_motor_cage printed part
-
4x M6x12 Cap Head Screw
-
4x 3030 Drop-in T-Nut - M6
-
-
-
z_motor_cage printed part
-
2x M6x12 Cap Head Screw
-
2x 3030 Drop-in T-Nut - M6
-
Loosely thread the 3030 T-Nuts onto the M6x12 screws. Do not tighten them at this point.
-
Position the Z-axis motor mount as shown. The base should rest on the rear feet
-
Fasten both M6x12 screws to secure the mount to the frame
-
Take care not to over tighten the M6x12 screws as you can damage the printed part.
-
-
-
3030 Drop In T-Nut M6
-
Slide the 3030 T-Nut behind the lower screw hole on the Z-axis motor mount as shown
-
Fasten the M6x12 screw into the 3030 T-Nut
-
Take care not to over tighten the M6x12 screw as you can damage the printed part
-
Slide the 3030 T-Nut behind the upper screw hole on the Z-axis motor mount as shown
-
Fasten the M6x12 screw into the 3030 T-Nut
-
Take care not to over tighten the M6x12 screw as you can damage the printed part
-
