Skip to main content
  1. Snap all the Endcaps (x8) in place.
    • Snap all the Endcaps (x8) in place.

  2. Cap Head Screw M5x12mm Z Top (Printed Part) 3030 Drop-in T-Nut M5
    • Cap Head Screw M5x12mm

    • Z Top (Printed Part)

    • 3030 Drop-in T-Nut M5

    • Screw T-Nuts into position, but don't tighten.

    • Snap Z Tops in position and tighten screws.

  3. You can look directly down through the holes on the Z Tops to make sure the Lead screws are perfectly straight.
    • You can look directly down through the holes on the Z Tops to make sure the Lead screws are perfectly straight.

  4. 3030 Drop-in T-Nut M5 Linear Rail Endcap (Printed Part) Cap Head M5x10mm
    • 3030 Drop-in T-Nut M5

    • Linear Rail Endcap (Printed Part)

    • Cap Head M5x10mm

    • Screw into position, but don’t tighten.

    • Insert the endcaps at the tips of the Y axis linear rails and tighten the screws.

  5. Button Head Screw M3x8mm Micro Limit Switch
    • Button Head Screw M3x8mm

    • Micro Limit Switch

    • Y Limit Switch Support

    • Cap Head Screw M5x12mm

    • 3030 Drop-in T-Nut M5

    • Screw T-Nut into position, but don't tighten.

  6. Fit the T-Nut inside the slot. Press the plastic part against the Cast Corner. Tighten the Cap Head Screw M5x12mm to lock the part in place.
    • Fit the T-Nut inside the slot. Press the plastic part against the Cast Corner.

    • Tighten the Cap Head Screw M5x12mm to lock the part in place.

  7. 2020 Drop-in T-Nut M3 Micro Limit Switch
    • 2020 Drop-in T-Nut M3

    • Micro Limit Switch

    • Cap Head Screw M3x12mm

    • Screw T-Nut into position, but don't tighten.

  8. Fit the T-Nut inside the slot Tighten the Cap Head Screw to lock the switch in place.
    • Fit the T-Nut inside the slot

    • Tighten the Cap Head Screw to lock the switch in place.

Finish Line

Rat Rig

Member since: 07/10/2020

32,286 Reputation

105 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 5

All Time: 1,928