Page 1 of 8
Next
Page 1 of 7
It was a publishing Error, Thank you for your feedback!
The jumper must be removed in step 6 , upon successfully flashing the Board
The Spool Holder kit is designed to be compatible both with 3030 frames and 2020 frames.
On the first guide (preparations), you’re instructed to cut your belt in half. You should use each of the halves on this step.
Hi! Nut tensioning is only required in some edge cases, when the Nut is too loose. By default, you don’t need to apply any tension.
422 on a 300, 522 on a 400 and 622mm on a 500. This can be checked at https://v-core.ratrig.com/bom/
Both those sizes will fit on a 300 bed.
Thank you for the heads-up. Fixed!
We double checked this and the measurements on the guide should be correct.
We double checked this, and M3x12 is the correct length.
Page 1 of 3
It was a publishing Error, Thank you for your feedback!
The jumper must be removed in step 6 , upon successfully flashing the Board
The Spool Holder kit is designed to be compatible both with 3030 frames and 2020 frames.
On the first guide (preparations), you’re instructed to cut your belt in half. You should use each of the halves on this step.
Hi! Nut tensioning is only required in some edge cases, when the Nut is too loose. By default, you don’t need to apply any tension.
422 on a 300, 522 on a 400 and 622mm on a 500. This can be checked at https://v-core.ratrig.com/bom/
Both those sizes will fit on a 300 bed.
Thank you for the heads-up. Fixed!
We double checked this and the measurements on the guide should be correct.
We double checked this, and M3x12 is the correct length.
Page 1 of 3
Next