Steps
4
- X-Gantry alignment 4 steps
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
User-Contributed Guide
This guide is not managed by the site's staff.
Private
This guide will not appear in search results and can only be viewed by team members!
Quiz
0
-
-
Push the X-Gantry foward
-
The space between the XY_Joiners to the front plates should be the same.
-
If the space is equal on both sides, you may skip to the next chapter.
-
If the space isn't equal and the gantry doesn't sit flush on front, please follow the next steps.
-
-
-
Lossen the Y- rail carriage screws a little bit.
-
Adjust the belt tensioning screw in order to equal the gap on both sides.
-
If you loosen the belt tensioning screw, the grantry will move foward, closing the gap.
-
If you tighten the belt tensioning screw, the grantry will move back, enlarging the gap.
-
Adjust both belt tensioning screws until the gap is equal on both sides and the gantry sits flush on the front plates.
-
-
-
still a draft....
-
something like moving the carriage
-
tighten the screws as you go....
-
-
-
Test the movement of the y-axis over the full travel distance
-
Small changes in resistance are normal, but becoming much harder to push, or binding completely are not
-
