Steps
4
- X-Gantry alignment 4 steps
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
User-Contributed Guide
This guide is not managed by the site's staff.
Private
This guide will not appear in search results and can only be viewed by team members!
Quiz
0
-
-
Push the X-Gantry foward
-
The space between the XY_Joiners to the front plates should be the same.
-
If the space is equal on both sides, you may skip to the next chapter.
-
If the space isn't equal and the gantry doesn't sit flush on front, please follow the next steps.
-
-
-
Lossen the Y- rail carriage screws a little bit.
-
Adjust the belt tensioning screw in order to equal the gap on both sides.
-
If you loosen the belt tensioning screw, the grantry will move foward, closing the gap.
-
If you tighten the belt tensioning screw, the grantry will move back, enlarging the gap.
-
Adjust both belt tensioning screws until the gap is equal on both sides and the gantry sits flush on the front plates.
-
Squeeze the XY-Joiner against the front plate to feel if there is any play. While squeezing there shouldn't be any play, keep adjusting the belt tensioning screws until there is not gap on either side.
-
-
-
still a draft....
-
something like moving the carriage
-
tighten the screws as you go....
-
-
-
Test the movement of the y-axis over the full travel distance
-
Small changes in resistance are normal, but becoming much harder to push, or binding completely are not
-
