Changes to Step #15

Edit by Rat Rig —

Edit approved by Rat Rig

Before
After
Unchanged

Step Lines

[title] Install the spoil board brackets
[* 2] 4040 extruded corner assembly (For the spoil board)
[* 3] Position the 4040 extruded corner assembly in the middle of the extrusion gap as shown
[* 4] The displayed measurement should be:
- [* 10] 202mm for StrongHold ONE 750x750
- [* 10] 327mm for StrongHold ONE 750x1250 or 1250x1250
+ [* 10] 220mm for StrongHold ONE 750x750
+ [* 10] 345mm for StrongHold ONE 750x1250 or 1250x1250
[* 5] Ensure that the top of the extruded corner assembly is flush with the top of the 4040 extrusions.
[* 6] Fully tighten the M8 cap head screw to secure the extruded corner assembly to the frame
[* 7] Repeat the above instructions for the remaining 3 extruded corner assemblies