Changes to Step #16
Step Lines
| [title] Ensure the base frame is square | |
| [* 10] Before continuing with the assembly, the frame must be squared and all screws full tightened | |
| [* 2] Using an engineers square, check that the side 40120 extrusions are square to the extrusions forming the base | |
| [* 10] On each side, tighten all of the following screws whilst continuing to check that the side extrusion remain square with the base: | |
| [* 3] 4x M8x16 within the cast corners connected to the base | |
| [* 4] 6x M12x45 on the motor and idler plates | |
| - | [* 5] |
| + | [* 5] 2x M8x22 on the motor and idler plates |
| [* 10] Once one side is fully secured and squared, proceed to repeat the process on the other side | |
| [* 10] After tightening all screws, check the entire frame once more for squareness. Correcting any issues now is easier than once the assembly is complete! |