Changes to Step #7

Edit by Rat Rig —

Edit approved by Rat Rig

Before
After
Unchanged

Step Lines

+[title] Install the Y bumper and linear rail - Part 2
[* 2] Install the two MGN12 3030 alignment tools as shown, this will make sure the linear rail is positioned correctly
[* 3] Slide the MGN12 linear rail into the Y bumper printed part
[* 4] Fasten the marked M3x12 screws, starting from the bottom
[* 5] Remove the MGN12 3030 alignment tools
[* 6] Repeat ***Steps 6 and 7*** and install the linear rail on the opposite side