Changes to Step #40

Edit by Rat Rig —

Edit approved by Rat Rig

Before
After
Unchanged

Step Lines

+[title] Install the upper Y motors - Part 6
[* 2] 2x Aluminium Spacer 6x10x30mm
- [* 10] Insert the spacer between the plates and alignment it with the holes
+ [* 10] Insert the spacer between the plates and align it with the holes
[* 3] 2x M6x50 Cap Head Screws
[* 10] Insert the screws through the top plate, spacers and bottom plate, threading them into the previously inserted M6 T-nuts. Do not fully tighten them yet