Changes to Step #8

Edit by Rat Rig —

Edit approved by Rat Rig

Before
After
Unchanged

Step Lines

[title] Assemble the left joiner - Part 5
[* 2] Push the two T-Nut Square type to the end of the assembly
-[* 3] Push the single T-Nut Square type underneath the printed part, ensuring it is aligned with the hole on the printed part.
+[* 3] Flip the gantry upside down and push the single T-Nut Square type underneath the printed part, ensuring it is aligned with the hole on the printed part.
[* 4] Repeat ***Steps7 and 8*** and prepare the other end of the assembly.