Changes to Step #18

Edit by Rat Rig —

Edit approved by Rat Rig

Before
After
Unchanged

Step Lines

[title] Assemble the right joiner - Part 5
[* 2] vc4_xy_joiner_lower plate
[* 3] 2x M5x8 Cap Head Screw
[* 10] Insert the screws through the plate, and tighten them to the t-nuts on the 2020 extrusion.
[* 4] M5 Hex Locking nut
[* 10] Thread a M5 hex locking nut in each screw
-[* 5] Tighten the screws in each the M5 hex locking nuts were inserted
+[* 5] Tighten the screws in each of M5 hex locking nuts were inserted
[* 9] Do not overtighten the screws as too much force can cause the gantry to bind when installed on the V-Core 4.