Changes to Step #29
Step Lines
| + | [title] Check if the gantry alignment |
|---|---|
| + | [* 10] Move the gantry to the front. |
| + | [* 11] Both Joiners must hit the Y bumper printed parts at the same time. |
| + | [* 2] An exaggerated example of a misaligned gantry, there is a gap on one side, but not the other. |
| + | [* 3] The right side sits flush with the Y bumper, or vice versa. |
| + | [* 10] ***If your gantry isn't bumping into both printed parts at the same time***, follow the next steps: |
| + | [* 4] Gently loosen all screws in both joiners. |
| + | [* 5] Push the joiners against the Y jumper printed parts by hand. |
| + | [* 6] Retighten all screws on both Joiners and go back to ***Step 26*** |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added