| | [title] Check the gantry alignment |
|---|
| | [* 10] Move the gantry to the front. |
|---|
| | [* 11] Both Joiners must hit the Y bumper printed parts at the same time. |
|---|
| | [* 2] An exaggerated example of a misaligned gantry, there is a gap on one side, but not the other. |
|---|
| | [* 3] The right side sits flush with the Y bumper, or vice versa. |
|---|
| | [* 10] ***If your gantry isn't bumping into both printed parts at the same time***, follow the next steps: |
|---|
| | [* 4] Gently loosen all screws in both joiners. |
|---|
| | [* 5] Push the joiners against the Y jumper printed parts by hand. |
|---|