Changes to Step #29
Step Lines
| [title] Check the gantry alignment | |
| [* 10] Move the gantry to the front. | |
| [* 11] Both Joiners must hit the Y bumper printed parts at the same time. | |
| [* 2] An exaggerated example of a misaligned gantry, there is a gap on one side, but not the other. | |
| [* 3] The right side sits flush with the Y bumper, or vice versa. | |
| [* 10] ***If your gantry isn't bumping into both printed parts at the same time***, follow the next steps: | |
| [* 4] Gently loosen all screws in both joiners. | |
| - | [* 5] Push the joiners against the Y |
| + | [* 5] Push the joiners against the Y bumper printed parts by hand. |
| [* 6] Retighten all screws on both Joiners and go back to ***Step 27*** |