Changes to Step #25

Edit by Rat Rig —

Edit approved by Rat Rig

Before
After
Unchanged

Step Lines

[title] Phaetus Rapido 2 Hotend - Part 3
[* 2] Insert the 2.5mm Cap Head Screws back in and tighten them.
[* 9] ***DO NOT*** overtighten the screws, they are only 2.5mm and will break if excessive force is applied.
[* 3] Tighten the set screw back in
[* 9] ***DO NOT*** overtighten the screw, if excessive force is applied the heatbreak will be permanently damaged.
[* 4] Put the socket back on
-[* 11] Try to insert the hotend on the toolhead and see if the cables align with the designated slot, if not, repeat ***Steps 28, 29 and 30*** and try a different angle in ***Step 31***
+[* 11] Try to insert the hotend on the toolhead and see if the cables align with the designated slot, if not, repeat ***Steps 23, 24 and 25*** and try a different angle in ***Step 22***