Changes to Step #51
Step Lines
| + | [title] Hybrid - Stepper motors - Part 2 |
|---|---|
| + | [* 11] This Step is only meant for the Hybrid and IDEX builds if you are building a V-Core 4 CoreXY skip this Step. |
| + | [* 7] Route the Y1 Stepper motor cable as shown. |
| + | [* 5] Route the Y2 Stepper motor cable as shown. |
| + | [* 3] Connect the Y1 Stepper motor cable to the second slot available on the Octopus Board, counting from the bottom. |
| + | [* 4] Connect the Y2 Stepper motor cable in the fifth slot available on the Octopus Board, counting from the bottom. |
| + | [* 9] The stepper motor wire colour order does not matter if the cable was supplied in the V-Core 4 kit. |
| + | [* 8] Use three wire clips prepared in Step 62 at the marked locations. Evenly distribute them along the extrusion. |
| + | [* 11] Proceed with ***Step 68*** |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added