Changes to Step #1
Step Lines
| + | [title] Prepare the Rapido Hotend |
|---|---|
| + | [* 2] Phaetus Rapido V2 UHF Hotend |
| + | [* 3] Cut the wires with 150mm and strip 5-10mm of the end, to expose the inside conductor. |
| + | [* 4] Cut the thermistor wires with 160mm and crimp a JST 2 connector |
| + | [* 10] The thermistor is a resistor that strongly varies with temperature. When crimping a resistor you don't have to worry about wire order as resistors don't have polarity. |
Image 1
No previous image
Added