Changes to Step #2
Step Lines
| + | [title] Connect the Rapido Hotend to the toolboard |
|---|---|
| + | [* 2] Hot End Heater 24V |
| + | [* 10] Insert the cable ends on the designated slots and tighten the screws. |
| + | [* 9] After tightening the screws, pull the cable to make sure it's firmly connected. If the cable releases/moves when pulling, reinsert it and tighten the screw. |
| + | [* 3] Hot End Thermistor |
| + | [* 10] Plug the connector into the designated connector. |
| + | [* 9] The thermistor wires are very fragile, bending them past its threshold can damage the conductors within, leading to wire failure. |
| + | [* 4] Insert the highlighted jumper to achieve more accurate temperature readings |
| + | [* 7] Route the wires accordingly. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added