Changes to Step #11
Step Lines
| + | [title] Connect the 4028 Cooling fan |
|---|---|
| + | [* 2] Cooling 4028 fan - 12 V |
| + | [* 3] Connect the PWM wire to the negative pin (the one closest to the middle of the toolboard) of the shown connector. |
| + | [* 4] Connect the positive and negative wire to the referred slot where the 12V jumper was placed. |
| + | [* 5] Route the power cable back to the electronics enclosure and follow the piano wire previously installed. |
| + | [* 10] Use some zip ties to clean the excess cable inside the electronics enclosure. |
| + | [* 7] Route the PWM wire as shown. |
| + | [* 8] ***IDEX ONLY*** Connect the 4028 cooling fan from T1 on the slot below. Ensure the jumper is set to 12V. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added