Changes to Step #13
Step Lines
| + | [title] Connect the Toolboard |
|---|---|
| + | [* 2] Cable - USB-A to USB-C Cable 1500mm |
| + | [* 3] Connect the USB C port on the toolboard |
| + | [* 4] Connect the USB A Port on the Raspberry Pi |
| + | [* 5] Red and Black Power wires |
| + | [* 6] Red Wire- Power Input +24V on the Toolboard and [+V] on the Power Supply |
| + | [* 7] Black Wire- Power Input GND on the Toolboard and [-V] on the Power Supply |
| + | [* 10] Route the cables back to the electronics enclosure and follow the piano wire previously installed - Use some zip ties to clean the excess cable inside the electronics enclosure. |
| + | [* 9] It is imperative to make sure that the USB-C connector cannot move! Tie it down to the printed part using some zip ties. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added