Changes to Step #14
Step Lines
| + | [title] Connect the Beacon probe |
|---|---|
| + | [* 10] ***Ignore this Step if you are wiring the IDEX T1 toolhead *** |
| + | [* 2] Beacon Z probe |
| + | [* 3] USB Beacon cable |
| + | [* 10] Connect the cable to the beacon and the Raspberry Pi |
| + | [* 4] Use two zip ties to ensure the cable is secure to the toolhead body. |
| + | [* 7] Route the cables back to the electronics enclosure and follow the piano wire previously installed. |
| + | [* 10] Use some zip ties to clean the excess cable inside the electronics enclosure. |
| + | [* 11] Have we mentioned how good the Beacon probe is? Just wait until you fire it up, you can find more info [link|https://beacon3d.com/|here]. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added