Changes to Step #11

Edit by Rat Rig —

Edit approved by Rat Rig

Before
After
Unchanged

Step Lines

[title] Connect the stepper motors
-[* 11] Insert te stepper motor connectors in the Rodent controller:
+[* 11] Insert the stepper motor connectors in the Rodent controller:
[* 2] Insert the X stepper in the top connector as shown.
[* 3] Insert the Y stepper in the middle connector as shown.
[* 4] Insert the Z stepper in the lower connector as shown.
[* 10] The colour of the wires does not matter, as long as the coil pair is maintained.