Changes to Step #10
Step Lines
| + | [title] Route the Y axis cables |
|---|---|
| + | [* 2] Route the endstop, Y-steppers cables as shown in the picture. |
| + | [* 3] Route the cables to the location where you desire to have the electronics components. |
| + | [* 4] Cut the cables to the final length, double check if the cable has the appropriate length before cutting. |
| + | [* 5] Label the cable at the end, with a piece of duct tape for example. |
| + | [* 11] If the endstop cable is too short, use the provided 3-wire cable and extend it following the same procedure as for the stepper motor in Step 14. Make sure to respect the colour order. |
Image 1
No previous image
Added
Image 2
No previous image
Added