Changes to Step #17
Step Lines
| [title] Prepare the Emergency button | |
| [* 2] Open the emergency button by removing the four screws | |
| [* 3] Open a hole on the emergency button body, either by snapping a removable disk or drilling a hole | |
| - | [* 11] Prepare two wires. These must be long enough to connect the button to the |
| + | [* 11] Prepare two wires. These must be long enough to connect the button to the PSU and Rodent. |
| [* 5] Insert one wire on one side | |
| [* 8] Tighten the screw to hold it in place | |
| [* 7] Insert another wire to the other side | |
| [* 8] Tighten the screw to hold it in place | |
| [* 11] Make sure to feed the wires through the hole made previously and close the emergency button with the four screws. |