Changes to Step #14

Edit by Rat Rig —

Edit approved by Rat Rig

Before
After
Unchanged

Step Lines

[title] Route the Y endstop
[* 6] Route the Y endstop cable as shown in the picture.
[* 4] Cut the cables to the final length, double check if the cable has the appropriate length before cutting.
[* 5] Label the cable at the end, with a piece of duct tape for example.
[* 2] Crimp the JST-XH into the wires ensuring the crimp has a solid connection to the wire core.
-[* 3] Inset the crimps into the JST-XH housing, to follow the shown wire colour scheme.
+[* 3] 1x JST-XH 3Pins
+ [* 3] Inset the crimps into the JST-XH housing, to follow the shown wire colour scheme.