Changes to Step #11

Edit by Rat Rig —

Edit approved by Rat Rig

Before
After
Unchanged

Step Lines

[title] Y Linear rails - Part 2
[* 2] Place the second Y linear rail assembly on the T-slot but ***DO NOT*** tighten the screws.
[* 3] Install the Y Joiner assembly on the linear rails.
[* 4] Using the 16x M3x6 Cap Head screws, fasten the XY joiner plate assembly to the mgn15 carriages.
- [* 10] MGN15 Rails should be tightened to 98 N-cm of torque, overtightening the screws will result in rail binging.
+ [* 10] MGN15 Rails should be tightened to 98 N-cm of torque, overtightening the screws will result in rail binding.
[* 10] ***Tip:*** Blue thread lock can be added to the thread of the M3x6 Cap Head screws.